Date:         Tue, 14 Aug 2001 08:58:58 -0700
Reply-To:     Matthew Pollard <poll7356@UIDAHO.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Matthew Pollard <poll7356@UIDAHO.EDU>
Subject:      Re: Weekender vs. Rear Seat
Comments: To: John Baker <abusguy2@SPRINGMAIL.COM>
In-Reply-To:  <Springmail.105.997802397.0.17209000@springmail.com>
Content-Type: TEXT/PLAIN; charset=US-ASCII

HI there, i have an 84 weeekender with THE backseat/bed. First place, i'll
never own another vanagon without one- it is that good.
Here is how it works. There is a knob that you pull out that is located
just above the rear heat-exhange. If you pull the knob out and lift the
seat up, it just hinges up and allows access to under the seat. Now if you
lift it up farther you'll hear two clicks and then you just pull up
and out a little and the back-rest will
slide to where the seat was and the seat (where you put your butt) will
slide forward and hang out.  IT is that easy.
Putting it back together is about as easy- you lift up the farthest out
part again till you hear two clicks and then push down and it will all
slide back in place. It is a very slick set-up.

The difference between this seat and other non-bed seats is that the
cushions don't have many bumps in them so it is more smooth to sleep on.

i hope you have one of these seats....
Matthew

Matthew Pollard          "Racing with the wind and flirting with death
Dept. Of Chemistry        So have a cup of coffee and catch your breath"
University of Idaho
www.uidaho.edu/~poll7356