The instructions for the TiiCo kit only mention the OXS in the final tuning section. Does this mean that there is wiring for the OXS in the harness? Or do we still need to wire it ourselves? If so, I see on the pin out for the ECU 2 places to plug the OXS in, but there are 3 wires attached to it. Where does the 3rd wire go? Also, where have you folks gotten the longer torque converter bolts? Lastly, my old 2.1l auto used 2 studs at the bottom of the motor, a bolt at the upper driver's side and the starter bolt/nut on the upper passenger side. The TiiCo kit has three studs and the starter bolt/nut. Do I just remove that upper driver's side stud, drill out the hole, and use a longer bolt, or what? Sean B. '90 V'gon, "Happy Bus", pseudo Wolfy Torrance, CA HTTP://www.vgonman.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.