Last weekend I got the wiring harness for my new TiiCo motor installed (along with the engine itself, but that's a separate post). The wiring went rather smoothly. I was able to identify where ALMOST everything was supposed to go. My question has to do with that little black box on the driver's side firewall. One "branch" of the harness is supposed to go in there. There is a round connector with 8 (I think) wires in it. No brainer. There is a red wire with a screw terminal connector on the end of it, again no brainer, it goes on the screw stud with the other red wire. The big question is... what does the yellow insulated spade connector plug into? There is a picture of what I'm talking about at the URL below. http://www.vgonman.com/tiicowiring.htm Thanks in advance for any help that you volks can give me. The victim is a 1990 2WD V'gon with an autotragic transmission. Sean B. '90 V'gon, "Happy Bus", pseudo Wolfy Torrance, CA HTTP://www.vgonman.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.