Date:         Sat, 8 Sep 2001 18:31:32 -0500
Reply-To:     Stan Wilder <wilden1@JUNO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1@JUNO.COM>
Subject:      Wiring VDO Cylinder Head temp.
Comments: cc: type2@type2.com
Content-Type: text/plain

I just purchased and *almost* installed a VDO cylender head temp gauge.
The sending unit is the type that goes under the spark plug on #3.
There are two wires coning out of the sender into a connector, there is a
connector that plugs into the sender connector and two wires,  one black
and one red (I'm going to assume that the black is ground).
I ran the pair of wires and connected them to the only two terminals on
the gauge, red to + and black to - (ground earth symbol).
I'm aparrently the second owner of this gauge because I didn't find
wiring instructions in the parts envelope.
I am assuming that this gauge isnt nuclear powered and will require
power.
So how does this bubba hook up?
I haven't hooked 12 volt to anything yet, but it has to get power from
some source.
Gauge kit # 310-901, 1-232-901-22d

Stan Wilder
83 Westfalia Air Cooled
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.