No need to disconnect vacuum lines. Jump idle stabilizer as you said. Connect timing light, using No.1 spark plug wire. Make sure idle is still in spec. 850 rpm or so. IF necessary adjust idle by turning large slotted screw on top of throttle body. Loosen dist. clamp bolt (10mm wrench) turn to adjust. "V" Notch is factory mark 5ATDC. "U" is TDC mark for adjusting valves, etc... Line it up with the case split. CCW advances timing, CW retards timing. You can try running at the TDC mark. I am running 4 BTDC. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.