Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2001, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 25 Sep 2001 10:11:21 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: Blinking Termperature Light
Comments: To: "Royston, Jerry" <gmr@OBPA.USDA.GOV>
In-Reply-To:  <3706B36A65176F4F8D6E73CEAB8BFC3824E1C2@obpa7w.obpa.usda.go v>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 10:08 AM 9/24/2001, Royston, Jerry wrote: >yesterday started up the engine and the red temperature light started >blinking immediately. Never had any overheating problems in the 5 months >since I bought the van. Is this merely a short somewhere? Is it still safe >to drive the van if the temperature guage stays in the normal zone? Is this >something I need to fix before a long trip? Thanks for any help.

1) Is the expansion tank (invisible until you open the engine cover) full? If it's half-empty, then the light is correctly warning you of a low-coolant situation.

2) If you unplug the connector to the level probe in the expansion tank and jumper across it, then turn the ignition on, does the light still blink (after the few initial seconds that it's supposed to)?

2a) From 2, if yes then you have an open wire, or bad detector module, or bad gauge. Unplug the module (on fuse/relay panel, has #43 on it in big white letters and turn on ignition -- does it continue to blink?

2a1) From 2a, if yes, bad gauge. You can swap it out or repair it by replacing the internal electrolytic cap. This is a big nuisance but possible -- you have to drill out the rivets holding on the face, then de-solder the internal board so you can get to the cap, replace it, reassemble, replace the face.

2a2) From 2a, if no, bad module or open wire. Ground pin 5 of connector K on back of relay panel -- should be Blue/Green wire. Retest. If still flashing, bad module, if not, bad wire.

2b) From 2, if no, then you have a dirty or corroded probe or connector, or coolant concentration wildly out of spec.

david

David Beierl - Providence, RI http://pws.prserv.net/synergy/Vanagon/ '84 Westy "Dutiful Passage" '85 GL "Poor Relation"


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.