Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2001, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 1 Oct 2001 16:39:27 -0700
Reply-To:     Shawn Wright <swright@SLS.BC.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Shawn Wright <swright@SLS.BC.CA>
Organization: Shawnigan Lake School
Subject:      Re: 2.1l main bearing - the whole story
In-Reply-To:  <OE74neS48qun63QxHPI00007fe3@hotmail.com>
Content-type: text/plain; charset=US-ASCII

On 1 Oct 2001 at 16:05, harald_nancy wrote:

> 2.1l main bearing set: > Just bugged a couple of VW dealers some more, and > finally found out the whole story. > It goes like this: > There were 3 different STANDARD main bearing sets originally > installed by the VW factory when the engine was built. > (These are NOT oversized bearings for machining the case or crankshaft.) > 025198461A That's the most common bearing installed. > 025198461A004 (red dot) It's 1/4000 next larger standard size (smaller > than blue). > 025198461A001 (blue dot) It's 1/1000 larger (largest standard size). > You don't know what bearings you have or combination of bearings until > you split the case and look for red or blue dots or no dots on your > crankshaft. > The first standard size is the smallest. So if you see any dots, blue or > red, > you need to get the corresponding larger size bearings. (See Bentley). > > In addition to these 3 standard bearings, the VW dealer sells > oversized bearings (.25 mm and .5 mm) for those engines > that need to be machined. >

Having nearly zero first hand experience in this matter (aside from assisting/watching several marine engine rebuilds 10+ years ago) I thought I'd mention that the above agrees very closely with an old diesel engine book I'm currently reading (and actually just read the section on main bearings last night). Right down to the fact that the factory often has 2 or 3 "standard" size bearings. It also goes on to state that middle sizes can be achieved where required by mixing a red dot upper shell with a blue dot lower shell, for example, in order to obtain the closest fit.

fwiw...

======================== Shawn Wright Computer Systems Manager Shawnigan Lake School http://www.sls.bc.ca swright@sls.bc.ca


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.