Howdy again volks, The raceware arrived tonight, but there were no instructions for a "cylinder head still on car" exchange included... Searched the archives, (both vanagon and yahoo-diesel), and found one reference. Basically, it said the short version was to drain the coolant, and then replace the studs one at a time. Can anyone comment on the accuracy of this? Anything I should watch out for? (Think I'll start w/ #1 out of Bentley, and follow the order out of there regarding bolt order.) Much thanks to everyone for all of their advice and help over the past several weeks, you guys rock! Thanks, John '82 Wet Westy |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.