Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2001, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 15 Oct 2001 19:47:21 -0400
Reply-To:     Harold Teer <teerhb@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Harold Teer <teerhb@HOTMAIL.COM>
Subject:      Cleaning electric mirror switch and increasing mirror adjustment
              range
Content-Type: text/plain; format=flowed

Recently, the switch which controls the adjustment on the outside mirrors on my '91 westy quit working after working sporadically for awhile. I searched the archives and the most common cause of this problem was identified as broken wires between the body and the door. My wires were fine, so I correctly guessed that the switch ($34.95 from Bus Depot) was the problem.

Since I didn't have anything to lose by experimenting, I decided to try and clean/fix the switch before ordering a new one. For anyone with the same problem and for the archives, let me explain what to do if you try to clean your switch. Gently and carefully, pry the switch apart near the wiring harness connector. The contents of the switch consist of "eight tiny springs", "four tiny barbells", a circuit board, and the joy stick controller. Luckily, most of the springs and one barbell stayed in place so I could tell how this thing worked. The joystick moves a piece of plasic which holds the springs and barbells and the barbells slide on the circuit board and make contact with different tracks which control the mirror motor. The barbells and circuit board tracks seemed to be made out of copper and looked pretty corroded. I had some Brasso Cleaner (remember, I had nothing to lose), so put some on my finger and rubbed it on the board until all tracks shinned again. I then cleaned the tiny barbells with the Brasso cleaner and then cleaned everything with alcohol. I reapplied a very tiny amount of silicone grease to where the plastic parts rubbed together---you will see where since there should be some old grease left. Looking at the worn places on the circuit board, you can tell where the barbells contact the board and this will guide you when you are deciding which holes the springs fit in to hold tension on the barbells. Then gently put everything back together. My switch is now working perfectly.

One thing that has always bothered me about the electric mirrors was the lack of range in their movement--especially the driver mirror. When working on the mirror switch, I happened to find that Bentley has a page (66.3) devoted to "increasing mirror glass adjustment range" for 1986 and up electric mirrors. Bentley provides an elegant solution--take a hacksaw and cut off about 1/8" on the four mirror stop tabs. I did this and it significantly increased the range of movement for the mirrors.

Hope this helps someone,

Harold >>>>>>>>>>>>>>>>>>>>>>>>>>> Harold Teer Harrisonburg, VA teerhb@hotmail.com '91 Westy

_________________________________________________________________ Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.