Richard Bias wrote: >I sealed, very well, with clear silicone, between my wind shield and >the rubber window seal. I think you'd find that, unless you can see water at the bottom of the glass on the INSIDE of the windshield, you need to seal between the windshield gasket and the BODY, not between the gasket and the windshield. I had wet carpet syndrome - and all kinds of water behind the dash and in the door footwells - until I went all around the outside with 3M DripCheck. (Had to do it twice, actually.) This is nasty stuff, isn't cheap, and requires an exotic solvent for cleanup, but it works. I highly recommend doing this with a helper who can hold the gasket open while you squirt in judicious amounts of the sealant. One drawback is that if you ever have to replace the windshield the new gasket probably won't seat tight unless you remove all the leftover dried DripCheck goop. -Steve |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.