The sizes should be marked on the back of your old main bearings. If you got away with polishing the crank they should be the same size. Stan Wilder On Fri, 26 Oct 2001 11:54:07 -0700 Rio Rafael <rior@GARLIC.COM> writes: > Hi everyone: > I am a bit confused as to how to determine which main bearing set to > order. > My crankshaft is a "red dot" unit (from an 85 1.9 liter engine). > > The mains measure > 1) 58.775 mm > 2) 54.972 mm > 3) not checked yet > 4) 40.005 mm > > My rod journals all measure right about 54.991mm. > > Any help will be appreciated. > Who stocks bearings, btw? > > Thanks > > Rio > ________________________________________________________________ GET INTERNET ACCESS FROM JUNO! Juno offers FREE or PREMIUM Internet access for less! Join Juno today! For your FREE software, visit: http://dl.www.juno.com/get/web/. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.