Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (November 2001, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 3 Nov 2001 09:52:48 -0700
Reply-To:     Blake Thornton <thornton@MATH.UTAH.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Blake Thornton <thornton@MATH.UTAH.EDU>
Subject:      AFM wierdness
Content-Type: TEXT/PLAIN; charset=US-ASCII

I have an 84 Westy and I took my AFM meter apart yesterday in the hopes of stopping the problem I've been having. What's been happening is that I lose all power suddenly, and almost as suddenly (sometimes) I get back the power. The van doesn't die, but it does absolutely nothing when I move the throttle.

So, I took looked at all the wires (and they looked ok) and then took out the AFM and tested it per Bentley. I also have another AFM (new AFM from here on out) thats been sitting around for a couple years that I compared to my old one.

In the resistance test, Bentley says to expect between 500-1000 ohms. Old AFM was at about 550 and new AFM was at about 750.

In the other test, you just hook up the ohm meter and move the wiper. The numbers seemed different as well. And, it also seemed for both AFM's, the resistance was not strictly increasing or decreasing. The ohms bounced around going up sometime and going down sometimes. it was wierd.

I also took the lid off the old AFM and everything looked fine inside. There was not a lot of carbon build up. I haven't taken apart an AFM before so I can't say if it was super clean, but it looked ok. I was a bit upset that I hadn't found the problem there.

So, I put the new AFM in my van and left the old AFM on a shelf. When putting it in my van, I tried an experiment. I tried running the van without the AFM connected electronically. The van ran a bit rough but it responded to the throttle. I thought this was odd as I had expected the van to not run at all without being hooked up to the AFM. I suppose the ECU adjusted the fuel mix according the O2 sensor? In any case, I decided that this showed that my problem is probably not an electrical connection between AFM and ecu (because when it happens to me, I get no response from the throttle).

Any comments or thoughts?

thanks, blake 84 Westy SLC UT


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.