Oops!! That was 10.0 mm. Dennis
-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Greg Marshall Sent: Saturday, November 03, 2001 8:55 PM To: vanagon@GERRY.VANAGON.COM Subject: oil pressure sender thread size. Hello folks, To install my oil pressure guage, I need the little hose adapter that allows the sender to be mounted slightly away from the engine. I found one for much cheaper than any of the usual vendors, but I'm unsure if the thread is correct. The seller says it is 1/8 npt on each end. Is this right? Is this the same thread as the hole it needs to go into in the engine and the vdo sender? Thanks again folks, you're all so helpful. Greg. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.