Date:         Sun, 18 Nov 2001 10:29:03 -0800
Reply-To:     Seth Bruggeman <SBruggeman@EXCITE.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Seth Bruggeman <SBruggeman@EXCITE.COM>
Subject:      stuff left for sale
Content-Type: text/plain; charset=iso-8859-1

Hello list-

Here is what I have left for sale--mostly stuff reclaimed from a blown
engine from an 84 westy.  Everything is--to the best of my knowledge--in
working order and in condition expected of parts from an engine with
180,000+ miles unless otherwise noted.  Pmail me at scbrug@wm.edu if you
have questions and/or offers.

Seth Bruggeman

1.  full set of lifters

2.  cam shaft w/ gear--no visible signs of excessive wear on journals on
lobes..

3.  throttle body--this is the two-switch variety; although I can't verify
it, I think this body was giving me poor gas mileage (i.e. i think there is
a crack in the body that's hidden or very small) because when i swapped it
with another, my mileage improved dramatically.  This said, I also changed
out wiring harnesses at the same time, so who knows???  Anyway, this is the
complete body with mounting screws, throttle linkage, idle screw arm, and
both switches (both relatively new).  I do not have the spring that puts
tension on the throttle linkage and idle screw arms or the nut and washer
that hold all three in place.

4.  half of an a/c compressor backet--the larger half that bolts to the
case--missing one mounting bolt

5.  distributor shaft

6.  power steering bracket with mounting hardware 

7.  metal coolant pipes:
         a.  pipe from t-stat housing to right head
         b.  pipe from water pump to right water jacket

8.  oil/case breather box/tube--the cylindrical black 
thing that bolts on top of case...

9.  complete t-stat housing with relatively new t-stat, 
does not include coolant temp sensor

10.  water pump with pulley

11.  four piston rods; only one with bolts connecting two 
halves of rod

12.  complete a/c bracket--both halves with all mounting 
hardware (this is not the same as the partial bracket 
above--i think this must be off an 85 engine--the same thing as far as i
know)

13.  complete manifold assembly including cast manifolds, 
breather box, the four woven sleeves connecting these, 
and the cross-over coolant pipe that bolts on 
above--missing one manifold to head bolt and the nuts 
for mounting the cross-over pipe...all metal parts 
freshly painted in gloss black and the woven sleeves are 
relatively new; was going to use this assembly on a new 
engine project, but gave up the project before it even 
started...

14.  rubber coolant hoses for engine compartment--the big 
set that wraps around back of engine between both 
heads--includes plastic junction and coolant bleeding 
valve (support tabs broken off of junction and coolant hose nipple on valve
broken off—i.e. don’t buy these just for the union piece)


15.  lower engine tin--both left and right pushrod cover 
sheet metal pieces; recently painted gloss black, but 
now covered with grease and grime...will clean up 
fine...

16.  coolant expansion tank (left tank) with coolant 
sensor and h-fitting--this is off an 85 but will fit 
others..needs cleaned and needs new coolant line coming 
off cap

17.  exhaust pipes--the front and back pipes that bolt 
onto the heads--both in very good condition with less 
than expected rust






______________________________________________________________________________
Send a friend your Buddy Card and stay in contact always with Excite Messenger
http://messenger.excite.com