Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2001, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 26 Nov 2001 10:52:23 -0500
Reply-To:     Phil Menchions <tassie@E-STELLA.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Phil Menchions <tassie@E-STELLA.NET>
Subject:      Re: greasing CV joints - Grease needle experience
Comments: To: Malcolm Stebbins <MSTEBBIN@MSVU1.MSVU.CA>

I use this needle to top up the CV joint grease almost every year. Instead of actually poking a hole through the CV boot I insert the needle between the axle and boot. I always assumed this was the way it was meant to be done.

Phil '89 Westy

----- Original Message ----- From: Malcolm Stebbins <MSTEBBIN@MSVU1.MSVU.CA> To: <vanagon@GERRY.VANAGON.COM> Sent: Monday, November 26, 2001 10:05 AM Subject: Re: greasing CV joints - Grease needle experience

> I did the grease needle thing on my van a year ago and > then took the van to Egypt for a year. Upon returning to > Halifax, my trusted mechanic poked around in one of the > CV joints and found packed SAND all over the place. He > pulled the other 3 CV boots and same thing, SAND > packed in the grease. All of this from a tiny needle hole > (but used in punishing conditions - desert sand). > > When I/we first did the grease needle thing, we/I did NOT > try and seal the holes with any sealant. I doubt that I do > the grease needle thing again except for an "emergency" > to get back home then do it properly. m2cw, Malcolm > > On 25 Nov 2001, at 18:45, Claudio Cella wrote: > > > I have a "srynge" type tool that fits at the end of a > > grease gun that would enable me to puncture the boot and > > get fresh grease in there. I would make one puncture > > close the the bearing races and pump in several > > ounces(?), then would work the grease into the > > neighbouring races by squeezing the rubber boot. Once > > completed i would seal the hole (approx. the size of a > > large sewing needle) with a dab of silicone seal. As far > > as i can remember the inner CV's have never been opened, > > the two outer's have had boots replaced and repacked a > > long time ago. What are your thoughts? Has anybody > > tried this before? Thank you for your thoughts. > > Claudio Cella >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.