Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2001, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 28 Nov 2001 17:19:13 -0800
Reply-To:     developtrust <developtrust@HOME.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         developtrust <developtrust@HOME.COM>
Subject:      Re: Missing Exhaust bolts
Comments: To: Blake Thornton <thornton@MATH.UTAH.EDU>

Bolts working loose? A week after buying my 1989 Vanagon camper while shopping at Home Depot in Encinitas California, my clutch popped & I could not get in or out of gear. AAA towed it to the dealership where I had an appointment to put on those cooling pipes I mentioned in my earlier messages.

It turns out all the bolts that hold the clutch linkage came loose and the last one just popped out. A blessing in disguise it turns out. Very easy to fix-- a ten minute job.

I had every other bolt checked while there. And I plan to crawl under every few months to check things out myself.

William

----- Original Message ----- From: "Blake Thornton" <thornton@MATH.UTAH.EDU> To: <vanagon@GERRY.VANAGON.COM> Sent: Wednesday, November 28, 2001 10:29 AM Subject: Missing Exhaust bolts

> I climbed in my 84 van this morning and turned it on, and boy did it sound > rough. I figured it was just cold (it was probably 15 degrees F here in > Utah this morning) and I figured the van needed to warm up. Well, it > sounded very rough the whole ride and when I got home I looked underneath > and took a look. > > Where the collector pipes (attached to the heads) meet the next pipe (the > pipe with the O2 sensor in it), there are four bolts (two for each pipe), > and I only had one. Somehow three of the bolts came undone! I put a new > exhaust gasket (it was missing where the bolts were missing) and put in > some new bolts, but why did this happen? > > I recently put on a new exhaust system (less then a month ago), and I am > fairly sure I tighten everything down good. Just to be sure, I checked > all the exhaust bolts and there were a few that were looser then I liked > (so I tightened them up). > > What do you think? Was I careless, or was the heating and cooling cycle > on a new exhaust system enough to loosen the bolts? Or was it something > else? > > Blake


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.