Randy, I don't exactly remember how that thing came out but just rip it out anyway you can. I went down to the auto parts store after I pulled out the 'plastic mistake' and sized it up to a brass heater core that somewhat matched it. Next, I secured it into the rear area and put a shut-off swich on the inlet hose. Place and secure the fan behind it and put the cover over the whole schebang. Your done!
Mike G. Randy Charrette wrote: > Well the heater core is leaking in the rear. I have removed the cover > and see 2 clips holding the front vent cover on. Then there is a > plastic case with the heater core and blower motor inside. How is this > case supposed to open. I expected to see screws going in the sides, > but there were not. I don't want to break anything! Detailed > directions appreciated! Randy Charrette87' Syncro weekender > > > ----------------------------------------------------------------------- > Get your FREE download of MSN Explorer at http://explorer.msn.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.