Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2001, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 4 Dec 2001 12:51:32 -0700
Reply-To:     Karl Wolz <wolzphoto@WORLDNET.ATT.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Karl Wolz <wolzphoto@WORLDNET.ATT.NET>
Subject:      Re: how to tighten starter wire nut??? Syncro
Comments: To: Matthew Pollard <poll7356@UIDAHO.EDU>

Pretty sure that I used a 13mm socket (perhaps with an extension?), but could have been a combo. I know I didn't have anything exotic with me under there.

Karl Wolz

----- Original Message ----- From: "Matthew Pollard" <poll7356@UIDAHO.EDU> To: <vanagon@GERRY.VANAGON.COM> Sent: Tuesday, December 04, 2001 12:05 PM Subject: how to tighten starter wire nut??? Syncro

> what wrench does one use to tighten the starter wire nut? I can get > combination wrench over it and but have no room to move it up and > down to loosen/tighten. Do i need an "S" shaped 13mm? Offset? > thanks > matthew > > Matthew Pollard "Racing with the wind and flirting with death > Dept. Of Chemistry So have a cup of coffee and catch your breath" > University of Idaho > www.uidaho.edu/~poll7356


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.