Never mind you all. I still had some daylight left and decided to take off the inner handle and door panel. I found the screw that holds the outer handle on to be almost falling off. I tightened it on and all is back to normal. Thanks anyway. Nothing in the Bentley book mentioned a loose handle but the diagram gave me a clue. William P.
----- Original Message ----- From: "developtrust" <developtrust@HOME.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Monday, December 10, 2001 4:11 PM Subject: Sliding door handle
I noticed that my sliding door handle is not flush to the door. The handle slides in toward the door and out about 1/2 inch or so. Is this normal? Or should I take the inside panel off to check out if something inside is loose needing attention? William P. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.