Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2001, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Wed, 12 Dec 2001 18:29:07 -0600
Reply-To:   "Smola, Tony" <TSmola@TRIBUNE.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   "Smola, Tony" <TSmola@TRIBUNE.COM>
Subject:   Re: To Shim Or not To Shim........That is the question
Comments:   To: Chris Stann <ChrisS@Informs.com>
Content-Type:   text/plain; charset="iso-8859-1"

The only problem is that my van is an 85' and 85's are very tall....almost 16" from

center of the hub to fender.....I don't think airlift will work because there is

already too much space between the snubber and the lower control arm.

And besides shims can be made for less than $5....either using Nylon cutting board or

special industrial plastics. I am leaning towards an aluminum shim screwed into

place.

Malibu Tony 85' Westy 1.9 L

rear measurement from ctr of hub to fender is 15 3/4 frnt measurement from ctr of hub to fender is 16 1/2

Looks like a one inch spacer will work fine.....no current leaning problem.

-----Original Message----- From: Chris Stann [mailto:ChrisS@Informs.com] Sent: Wednesday, December 12, 2001 3:52 PM To: Smola, Tony; vanagon@GERRY.VANAGON.COM Subject: RE: To Shim Or not To Shim........That is the question

Here's what you want. An air-bag-type helper. You can vary your bag pressure for different loads and adjust according to need.

http://airlift.r-catalog.com/listparts.asp?mmid=102073&fldnum=0&prod=3

Use the website to find a dealer near you. I'm getting mine soon.

Chris.

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf Of Smola, Tony Sent: Wednesday, December 12, 2001 5:39 PM To: vanagon@GERRY.VANAGON.COM Subject: To Shim Or not To Shim........That is the question

I'm pretty sure that I've decided to shim my 85' Westy 2WD in order to level her out......sagging rear you know.

Is there a simple template that I can make for the rears?

What material should I use?

How thick of a shim can be installed safely?

Thanks,

Malibu Tony 85' Westy 1.9L 6 degrees BTDC


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.