I'm in need of the spacer that goes between the engine fan and the fan drive hub on a Type IV 2000cc engine. It is a round disk with four holes in it, three of the holes are for fan mounting bolts and the forth is for the small alignment pin. In the vent that I can't find the flat spacer I can use an air conditioner pulley (fan location) for the same purpose. If you've got one of these lying around I'd like to have one to complete an engine rebuild. Stan Wilder 83 Air Cooled Westfalia ________________________________________________________________ GET INTERNET ACCESS FROM JUNO! Juno offers FREE or PREMIUM Internet access for less! Join Juno today! For your FREE software, visit: http://dl.www.juno.com/get/web/. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.