In a message dated 1/1/02 12:12:41 PM Eastern Standard Time, dhaynes@OPTONLINE.NET writes: << It is there to locate the flywheel in position on the Crank shaft so that the pin one the back is in the correct place for the "Top Dead Center" sensor for some VW diagnostic tools. >> Yeah that too..but the pin has been in there since 1968 when the engine was introduced (411/914-4) Steven M. Denis 3642 Longleaf Drive Elm City, NC 27822 "Hey! nice Jeep, Mister! " "Look kid, it's NOTAJEEP! " |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.