I'm still working on my CV joints but need to replace some other things while Everything is disassembled. I have run into a problem... Help! I cannot get the lower ball joint to budge. I searched all over today for the special tool shown in the Bentley to press it out, the only ones I found were too small to do the job. I have been spending far too much time on this and it is quite frustrating! I searched the archives and found nothing t o help with this. Anyone have any sage advice to share? TIA Loretta |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.