Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2002, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 9 Jan 2002 21:00:53 -0600
Reply-To:     John Rodgers <jhrodgers@MINDSPRING.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Rodgers <jhrodgers@MINDSPRING.COM>
Subject:      Re: Idle stabilizer
Comments: To: Blake Thornton <thornton@MATH.UTAH.EDU>
Content-Type: text/plain; charset=us-ascii

Blake, the idle stabilizer on my 88 GL gives me the same trouble, so I am running with it disconnected. It runs real somooth that way. Without it, however, cold starts are a pain, because the Idle Stabilizer Valve (ISV) keeps the engine idling at 1000 rpm when cold. The operation of the valve is related to the signal from the Temp II sensor to the ECU. Cold, the ECU circuit signals the ISV to do its thing and regulate idle speed. Once warm the Temp II signal is cut from the circuit. So if you disable the ISV the signal from the ECU has no place to go, so the engine will stumble until it warms up. After that, it runs smooth.

The other thing the ISV does is kick up the idle speed if the AC is turned on. If you are slowing down or stopping for a light or something and the engine idles down, the load from the AC will kill the engine unless the idle speed is kicked up a bit to carry the AC compressor load. So the ISV does its thing.

I two would like to know why this problem with the ISV even exists. I have not found a solution except maybe replacing the thing, and its an ex-ensive item on the later vans.

John Rodgers 88 GL Driver

Blake Thornton wrote:

> In an effort to find my electrical gremlins, I bypassed the idle > stabilizer. My idle went from "searching" to smooth. I wan't running > poorly before (except when the gremlin took over and killed it), but with > the idle stabilzier bypassed, it seems to be running much better. > > Could someone explain to me what the idle stabilizer does and what happens > when it is bypassed. > > Thanks, > Blake > 84 Westy > SLC UT


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.