Date:         Wed, 16 Jan 2002 15:51:12 -0600
Reply-To:     Stan Wilder <wilden1@JUNO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1@JUNO.COM>
Subject:      Re: Overhaul an 81 air cooled
Comments: To: jbrush@AROS.NET
Content-Type: text/plain; charset=us-ascii

Yes it can be done with the engine in the vehicle.
Install 6" long bolts in the mustache bar mounts at each end and drop the
engine down in the rear. It gives you much more room to work.
Pulling your pistons has to go in a special rotation to clear the oil
cooler mount and there are just a few other tricks.
However having done it that way I can tell you it doesn't save any time
or labor in the long run.

Stan Wilder

On Wed, 16 Jan 2002 13:59:34 -0700 John Brush <jbrush@AROS.NET> writes:
> -
> Hi all,
>
> I have been gone for a time, but am out of work now, and actually
> have
> time to read all these messages, plus I am anxious to make a
> decision on
> my vanagon's future.
>
> Short and sweet, I would like to ask if it is possible to overhaul
> the
> 'top end' of the motor without pulling it from the van? Rings,
> bearings,
> and valve job are what I am looking at. Is there room for the
> cylinders to
> come off?
>
> Thanks for your time,
>
> John
>
>
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/web/.