I noticed that an oil slick is forming on the block behind the vaccuum pump. I guess the angle the engine is mounted at along with the intermediate shaft oiling groove is causing a bit of oil to get out of the block where the pump is attached. Is there something that can be done to minimize this mess? Bradley Flubacher State College, PA '81 diesel rabbit '82 diesel westy '82 diesel van '84 GL wasserboxer |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.