I am getting to re-do the CHT (the PO had a botch job), I have run new wires... how long should they be ???? > -----Original Message----- > From: Stan Wilder [mailto:wilden1@JUNO.COM] > Sent: Wednesday, February 13, 2002 12:44 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Re: cylinder head sensor location > > > The circle goes under your spark plug on number #3 cylinder. > The sender > (the round terminal is a thermo couple) it emits a minute amount of > current to power the CHT gauge (do not put 12v to this > gauge). Red wire > positive other wire black to negative on your gauge. It is recommended > that you not lengthen the wires that come in the kit. If you lengthen > them ....... make solder connections. > > Stan Wilder > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.