Do all O2 sensors have this braided wire? I have an 82 california van with an O2 sensor, the single wire type. If i want to lengthen the wire to fit the sensor in my new exhaust system, will I encoutner this same braided wire problem? thanks.. greg. 82 westy. Rico Sapolich wrote: > In a message dated 1/23/02 10:31:55 AM, dbeierl@ATTGLOBAL.NET writes: > > << just strip the braid back far enough that it can't short to the crimp > terminal. >> > > Terminating the shielded O2 sensor wire this way replicates the factory > scheme, complete with its shortcomings. A slight, but significant, > improvement can be made if about 3/8 inch the outer jacket is first stripped > away (without nicking the shield!) then the braid is combed back over the > outer jacket. A short piece of shrink tube is applied to finish the end and > to hold the braid in place. This method provides somewhat of an eased edge > upon which the soft inner conductor insulation can bear and lessens the > opportunity for the shield, backed up by that tough outer jacket, to cut > through it. > > Rich |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.