Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2002, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 13 Feb 2002 19:58:34 EST
Reply-To:     JM060356@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Morgan <JM060356@AOL.COM>
Subject:      O/2 sensor green wire repair
Content-Type: text/plain; charset="US-ASCII"

I have found the green wire to the O/2 sensor had one to many splices/ bad connections. I know that I have to use high temp coaxial wire but where do I get it. The archive was vague. Have tried radio shack and they were of no help. Any ideas as to where? Or How about a way to shield regular wire? The repair runs from the connector and is aprox 10 inches long. Runs by the coil and plug wires so I want to be sure that I get a good signal from the sensor.

Any Ideas?

Jim Morgan 86GL "Breadbox"


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.