I have a problem w/ my temp. (degree) gauge. My water level light works perfectly.....blinks initially then after registering water level ok, it turns off.... I never get anything out of my temp. degree gauge, which is odd because it worked reliably prior to my recent head gasket job....... Any thoughts of what "I left off" to cause this......all my FI grounds are good (I am running well otherwise......). Mine has two sender unit wirers on my thermostat housing: (1) FI type w/ clip, and (2) a female (1/4 inch) that clips over plug. Which wire (2 mentioned above) does what??? Pls. advise as to how to check system and get my temp. degree gauge working again....its too important. Larry __________________________________________________ Do You Yahoo!? Yahoo! Sports - Coverage of the 2002 Olympic Games http://sports.yahoo.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.