Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (February 2002, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Thu, 21 Feb 2002 16:27:44 -0800
Reply-To:   John Clemens <jbclem@EARTHLINK.NET>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   John Clemens <jbclem@EARTHLINK.NET>
Subject:   Re: Shims Swaybars CVs and Steve's Spings
Comments:   To: Derrek Wittmann <kerred@HOTMAIL.COM>
Content-Type:   text/plain; charset="iso-8859-1"

Derrek,

Could you tell me where you bought the sway bars for you Vanagon, and any other information that would be relevant.

Thanks, John

----- Original Message ----- From: "Derrek Wittmann" <kerred@HOTMAIL.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Thursday, February 21, 2002 11:06 AM Subject: Shims Swaybars CVs and Steve's Spings

> I got a set of Steve's springs. They are great. My van was restored to the > stock ride height plus a little. I added shims on all four corners. > 12mm(1/2") in the front > 19mm(3/4")+12mm(1/2") in the back. > With all the shims I have added it is a little too tall in the back. This > lead problems with my old cv's. I had to replace them with good used ones. > The new steeper angle of my axle had changed the range of motion that my CVs > were going through. It was just too much for my worn out CVs. I still have > a slight vibration. I should take the small shim out but I like the way it > looks. The rear axel to fender lip height is 18". The addition of a 1" > swaybar in front made the biggest difference on the reduction of sway. > Later I added a rear swaybar which I did not feel the effect of as much as I > did the front. > > Derrek Wittmann > ----- Original Message ----- > From: "phil stanhope" <napszeerf@YAHOO.COM> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Thursday, February 21, 2002 6:17 AM > Subject: Re: [VANAGON] New springs on my 1989 Vanagon with shims for the > lefty camper sway > > > > Could you say that this is a better solution to reduce > > sway than to add front and rear sway bars? I would > > much rather do this if it REALLY reduced swaying, and > > from reading Developtrust's posts it seams to be so. > > > > > > Phil, > > 84' "Westy Millenium Falcon" > > > > > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.