Eric Peterson wrote: >1989 Vanagon 2.1L 2-wheel drive 125k > >[snip] > >Issue 1 - I have a leaking clutch slave cylinder and I am planning on >replacing it. The clutch master cylinder was replaced 10k ago. I have read >numerous posts on the archives emphasizing the importance of replacing both >slave and master at the same time. My question is...is replacement of both >master and slave at the same time only necessary when both have numerous >miles on them? Since the master is relatively new (10k), I was hoping I >didn't have to replace it. I know it is my risk, just asking. If anyone has >replaced only one with the other being fairly new and has information to pass >on, please do! > >[snip] > The two parts just wear out at roughly the same rate, as you've discovered with the slave dying so soon after the master. That's why everybody recommends changing them both at once. If one croaks the other is about to, so save yourself some time and hassle by doing both at once. Not necessary in your case. Just change the slave this trip. Ed Nutter |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.