Digijet injector resistance should be between 14 - 18 ohms ea. Usually 16. If you are measuring, watch out for the Auxiliary air regulator which is in parallel with the injectors and will falsify your reading, depending on where you do the measuring. I dont think you can check an Oxy sensor by measuring its resistance. Steve Cotsford |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.