Date:         Sat, 23 Feb 2002 14:46:17 -0000
Reply-To:     Alan Shearer <acs0207@MYBLUELIGHT.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alan Shearer <acs0207@MYBLUELIGHT.COM>
Subject:      Re: AT Seal and Gasket Replacement
Comments: To: gstelz1@YAHOO.COM
Content-Type: text/plain; charset="us-ascii"

Hi Greg,

I really didn't have a choice whether to remove the piston or not. When I removed the circlip holding the piston cover in place, the piston was forced out by spring tension. While it was out, I checked the condition of the seals and found they were hard and brittle, so I replaced them.

Regards,

Alan

Hi folks,

I have been following this thread because my auto
tranny has developed a small leak.  It runs and shifts
fine.  I was planning on just replacing the pan gasket
and brake band cover o-ring.  How would you know if
the piston seals are leaking?

Thanks,
Greg Stelz
86 GL to westy conversion

Hi Walter,

I didn't remove my transmission. I just replaced the
pan gasket, the
two 2nd gear brake band piston seals, and two brake
band cover O-rings. I
bought the new circlip at my local VW dealer and
replaced it as a
precaution. It probably wasn't necessary. Sounds like
maybe you have a kit
for a complete transmission overhaul...

Regards,

Alan


__________________________________________________
Do You Yahoo!?
Yahoo! Sports - Coverage of the 2002 Olympic Games
http://sports.yahoo.com