I am trying to get Pooh ready for our yearly trip south and in doing a tune up I am faced with 2 issues. I cannot get the O2 sensor out of the cat...tried heat and have all but destroyed what was once a sensor...I am now using a plumbing pipe wrench! Also when replacing the cap and rotor, the plastic plug on the side of the distributor broke. Is there a particular position that that fitting must be in? Can I silicon it back on...the wires are fine? THANKS! Finn |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.