Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2002, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 9 Mar 2002 14:24:22 EST
Reply-To:     Finrun@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Finn Runyon <Finrun@AOL.COM>
Subject:      Help O2 and Halls Sensor
Content-Type: text/plain; charset="US-ASCII"

I am trying to get Pooh ready for our yearly trip south and in doing a tune up I am faced with 2 issues. I cannot get the O2 sensor out of the cat...tried heat and have all but destroyed what was once a sensor...I am now using a plumbing pipe wrench! Also when replacing the cap and rotor, the plastic plug on the side of the distributor broke. Is there a particular position that that fitting must be in? Can I silicon it back on...the wires are fine? THANKS! Finn


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.