Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2002, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 10 Mar 2002 18:59:58 -0800
Reply-To:     dennis lockwood <luvoldvws@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         dennis lockwood <luvoldvws@YAHOO.COM>
Subject:      Re: Temp II sensor replacement
Content-Type: text/plain; charset=us-ascii

I risk heresy to write the following. I wear flame proof underwear so feel free to flame me. BTW, the following describes the process on a 91 Vanagon. Other years may differ.

Twice I have done the following procedure successfully. I have pulled the Temp II sensor, let the coolant flow out, replaced the sensor with a new one, poured the used coolant into the reservoir, fired it up to check my work and drove on. No, I never have bled the coolant system after replacing the temp II sensor, did not need to.

Make sure the engine is cold, like first thing in the morning after the van sets all night. You need to pull the wire bail that holds the sensor in the thermostat housing. I use a pair of needle nose pliers and some salty language. Sometimes you can pry the bail out with a broad, short screw driver. Put a catch pan under the tstat housing to catch the coolant that will surely flow out. Remove the electrical connector from the sensor. Hint, push against the wire bail that holds the electrical connector on the sensor. The sensor will slide off easily. Pull the temp II sensor from the tstat housing, it should slide out with moderate effort. Verify that the o-ring came out with the sensor. When the sensor is removed from the tstat housing, coolant will gush out freely. Don't panic. About two quarts will come out, and then the flow will stop. Replace the sensor and o-ring. Make sure that it is inserted all the way. Make the electrical connection (it should snap on assuringly). Replace the wire bail that secures the sensor. Make double sure that it is secured properly. Refill the coolant into the reservoir and top up to accommodate any lost coolant. Start the engine, burp the air out of the reservoir as many times as is necessary.

This procedure works as long as your van has a good thermostat that closes tightly and the engine is ice cold. It should work for you also. Hope this helps.

Dennis Lockwood 91 Carat Original Owner

__________________________________________________ Do You Yahoo!? Try FREE Yahoo! Mail - the world's greatest free email! http://mail.yahoo.com/


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.