Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2002, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 13 Mar 2002 14:24:40 -0500
Reply-To:     Ben huot <huotx@VIDEOTRON.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Ben huot <huotx@VIDEOTRON.CA>
Subject:      Oil pressure sander/switch #2 location

Simple question, I done many repair-works-modification on my 2.1 engine but I never found the second oil sender (never really look for it), not the one located between the left pushrods, the one near or in the oil pump.

I went to a great site (modification of a 2.1 engine water cooled in an air cooled) There is many great pictures of the 2.1. So if could take a look the following picture an point me the location of the second sender I would appreciate.

URL: http://www.gearheads.dk/oxybilleder/oxy_Case_front.JPG

Regards, Ben


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.