Regards Please take a look at a specific picture on my web site (in construction) http://www3.sympatico.ca/huotx/oil_pressure_sender_overview.htm I would need confirmation on the color/wiring/connector for the .9 BAR rear oil sender. Mine was (Previous owner) cut near the sender (I think it was cut by the belt) and it was so difficult to reach that the PO grounded the wire to the engine, this way the signal to the oil light look OK. (close). (I hope….. oil pressure was taken by my friend last year and was OK, but I was not there to see!!!) If you could check your van and confirm that the 2 brown wire that come from the same connector (see picture) goes to each sender. By Bentley 97.108, it confirms what I am thinking. I would like a physical confirmation from one of you guys. If not, can you tell me where the .9 rear sender brown wire goes? Best regards, Ben |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.