> I'm wondering if anyone can give me an idea of how long it takes to pull > the BA6, whole and complete with all the jeebers. Any tricks I should > know about before diving in? We may have the option of rolling the van > on its side since it is completely stripped else wise, would it be worth > it to not have to lay under?
I did this on a late model bus, which has the same heater but minor differences in layout. As I recall, the only pain in the neck was feeding the wiring harness through the holes in the chassis frame in order to get it out in one piece (which took as long as everything else put together). Of course, don't forget the underdash relay/fuse parts and the sensor in the heater duct tube toward the front of the van. Otherwise, it was not a very difficult job (and no need to roll the van in my opinion). - Ron Salmon The Bus Depot, Inc. (215) 234-VWVW www.busdepot.com _____________________________________________ Toll-Free for Orders by Part # 1-866-BUS-DEPOT |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.