I am expecting a new engine from Boston Engine this week and am making plans to remove the old engine this weekend. I am going to design a cradle to support the tranny as in the Bentley, that willl allow it to drop down about 4 inches. How far do I have to raise the back end to have sufficient room to get the engine out? I am not sure I have enough ceiling clearance to do this in my garage. I will probably end up doing the entire swap in my driveway. Should I run the back end up on ramps or do I not need this much height? Is 4 or 6" of blocks OK or should I use two jacks and jack stands? I don't want to take it up any higher than necessary. Jay |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.