|
Hey Tracy, Check the grounding point behind the fuse panel. It is a cluster of grounds all mounted on a circular connector. I had trouble with my head lights and other lights in the dash area. My windshield seal had leaked and corroded the ground. You have to remove the fuse panel to get to the ground. I think there may even be two sets of grounds in that location. Colin "Bronze Brick" '86 Syncro GL From: Tracy Bonin <tracyb1420@PHUNKYBITCHES.COM> Subject: windshield wipers/heat control 85' Hello, well my windshield wiper controls/heat controls aren't working. (yes I checked the fuses) A little while ago they were very touchy, and they only worked once the engine was warm (that was the pattern anyway) but now they don't seem to be working at all. The other night I was driving around, and they popped on about an hour after I'd been driving. Since then, they haven't been working at all. Any clues anyone? Any help is appreciated. Thanx |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.