Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2002, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 18 Mar 2002 13:18:57 -0500
Reply-To:     Jamie Ayotte <jayotte@DESTEFANOARCHITECTS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jamie Ayotte <jayotte@DESTEFANOARCHITECTS.COM>
Subject:      "Maybe" some progress towards remedying my no-start/bucking/stall
              ing
Content-Type: text/plain; charset="iso-8859-1"

hey marshall, the same thing happenned with my 86... it was a bad ignition coil, only about $40.00 US... >

------------------------------

Date: Sun, 17 Mar 2002 18:12:29 -0600 From: Marshall <mjruskin@SHAW.CA> Subject: "Maybe" some progress towards remedying my no-start/bucking/stalling condition

Hi Volks:

Thanks to Terry K, Andrew Bell, Joe Romas, William "Developtrust", Richard Jones and the irreverent Joel Walker for their help. A great big thanks to local listee Jeff Palmer, who interrupted his "thesis-writing" to drive me to the store!

If I missed somebody, I am sorry, and I hope you'll forgive me....

Here's the story/saga:

I bought a new rotor and cap today ("Wells" brand - all they had) at Canadian Tire, and installed them.

There was some moisture on the old rotor's body. Yup.

Van fired right up with new rotor and cap, and I drove for about 5 minutes before the bucking started again - bucking and stalling like before. It's puddly and slushy out, fwiw.

* I noticed when I had attached the plug wires to the distributor, how little grip the distributor cap had on the plug wires - they'll lift off with hardly any force at all. A sparrow could easily pluck them out., (Watch out for that belt and pulley, Mr Sparrow!... ..oh geeze!)

So, I wonder if this is normal for plug wires - or if I should buy a new set - I don't know how old mine are, but they're at least 3 years old.

* I also noticed that there was a convex dished plate that sat below the rotor, and above the distributor body - this plate seemed to not have anything to grip it - it looks like it should snap down - but it just sits there. Hmm.

Because my parking stall is full of slush, it wasn't safe to jack up the van to put in my new fuel filter - but I guess a plugged filter could also be a cause of the problem.

All suggestions (helpful, that is) are welcomed.

Marshall Ruskin 84 Westy "The Weekend PITA"

------------------------------

End of vanagon Digest - 17 Mar 2002 - Special issue (#2002-302) ***************************************************************


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.