-----Original Message----- From: Forhan, Thomas <Thomas.Forhan@mail.house.gov> To: 'syncro@yahoogroups.com' <syncro@yahoogroups.com> Sent: Tue Apr 02 13:14:48 2002 Subject: Clutch slave cylinder question I'm installing yet another trans and swapped in my previously working clutch slave cylinder. Now I am trying to bleed to system to no avail. Air just keeps reappearing at the hard hose, and we are not moving much fluid into my little jar. No visible or audible leaks, hard hose to slave looks good, banjo bolt has two copper washers... Anything else? Should I elace the clutch cylinder (what a hassle without dropping the trans). Any other ideas out there? Thanks Tom F. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.