You must take off the valve cover and determine if you have the 11mm hex head bolts or the 12mm triple star head bolts. You must count the notches on the front of the engine as well. With those two facts, you can order the gasket that is currently installed. Ideally, you would measure the piston projection above the block surface, then order the right depth, but I doubt it will be other than what you have already. I've measured several engines, and they've all been correct so far. Living in San Diego, I would certainly think you can find the head gasket locally. I would recommend establishing a sort of relationship with a local foreign car parts store. By an oil baffle for the head while your at it. If you have the 12mm bolts, you'll need to order a replacement set of them as well. Also, you'll need a triple star (sometimes called serrated bit) set. I found my set at Pep Boys for about $10 I think. Lisle I believe is the manufacturer. Replace the thermostat, timing belt and water pump while you have everything apart! Also, in order to time it correctly, you'll need a 1" dial indicator ($10 at harbor freight, you have one locally). Plan on spending about $100-150. Brad
Matt Ratto wrote: >Hi all, > >after some more attempts to diagnose the problems with the diesel in my 82 >westy, I'm pretty sure I'm suffering from a blown head gasket. The coolant >bubbles (a lot) when the engine gets hot, so much so that I can't bleed the >system. Also I noticed a trace amount of oil in the coolant and continuous >white smoke at idle. I thought the smoke was oil from worn rings, but after >taking a trip through the archives I'm thinking it might be water. The final >factor is that I have very low compression on 2 & 3 but not on 1 & 4. It's >all kind of moot because I really want to put a new motor in the thing. >Still, until that happens, it would be nice to have a running vehicle. > >So the question is: how can I tell in advance (without removing the gasket >and looking at the notches or measuring the pistons,) which head gasket I >need? I don't really have a place to leave half-dismembered vehicles, while >I wait for the head gasket to arrive from busdepot or another shop. > >any help would be greatly appreciated, > >Matt > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.