Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2002, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 5 May 2002 16:05:15 -0700
Reply-To:     Mark Dorm <mark_hb@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Dorm <mark_hb@HOTMAIL.COM>
Subject:      Re: Main Engine Bearings
Comments: To: bostneng@FCL-US.NET
Content-Type: text/plain; format=flowed

So Bob, even if I had your Big Valve Engine Option III, you would still keep 70 mph as your maximum sustained speed. And if a rod is distorted can you replace individual rods? Sorry for my mechanical ignorance, I'm learning though. Finally bought a Bently. I'm interested in your big valve option, but I'm gonna have to make some money. Whats the turn around and installation price if I were in your neighborhood?

>From: Robert Donalds <bostneng@FCL-US.NET>

>Mark > >the 2.1 engines with over 130k miles have issues with the big end of the >rod distorting and throwing rods one of the symtoms is low oil pressure at >warm idle. http://www.bostonengine.com/articles/low-oil-pressure.htm doing >80 with an older 2.1 is not recomended I would say that 70 is the max >sustained speed for a van engine. That is 4000 RPM its about the same std >and auto trany.The WBX engines I have taken apart over the years have some >comon problems exhaust valve seats that are pounded is one I think to much >sustained RPM is one reason for this. > >Bob > >Mark wrote > I was driving down Interstate 5 heading due south, going about 80 mph, >saw >a gas station, decided to exit when at that moment the buzzer went on. >Water >temperature wasn't higher than the top of the led itself. I turned the >engine off, and coasted down the road, into the denny's parking lot next to >the gas station. Let it cool, let my mind run wild. Added more than half of >a bottle of gunk. Wasn't low on any fluids. After a few hours, I started, >it >ran, and I drove 60/65 mph all the way to Riverside. No problems since >then. >Thinking is, oil got hot which made it thin out which caused the oil >pressure to drop. It wasn't that hot that day. Is this just a day in the >life, or is it an omen?

_________________________________________________________________ Send and receive Hotmail on your mobile device: http://mobile.msn.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.