OK, so, I took out the driveshaft. I don't think the u-joints are bad. Now the vibration that came on at 3600 RPM and stayed until 4100, under load, comes on at 3200-3400. What could it be? On Thursday, May 23, 2002, at 06:03 PM, Brent Christensen wrote: > You can drive it without problems, based on the collective experience > of the > Syncro List. (I have personal experience doing this as well) > > Brent Christensen > ----- Original Message ----- > From: "Simon Reinhardt" <simon@FARRSIDE.NET> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Thursday, May 23, 2002 4:46 PM > Subject: Drive without a driveshaft? > > >> Hi all, >> I need to pull the driveshaft out of my syncro to replace the U-joints. >> While it's out, can I drive the van, or will that turn the VC into the >> Amazingly Expensive Grenade from Hell? >> > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.