Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (May 2002, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Mon, 27 May 2002 08:08:04 -0700
Reply-To:   Tromper <evilpig@MINDSPRING.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Tromper <evilpig@MINDSPRING.COM>
Subject:   Re: Removing & replace OEM cup holders
Comments:   To: BenTbtstr8@AOL.COM
In-Reply-To:   <7679143E.04232F87.0AA62B84@aol.com>
Content-Type:   text/plain; charset="iso-8859-1"

Since I's an ign'ant git does someone have a pic of where these mount to show me so's I 'kin retro 'em into my Dieselfant??

Tromper 1982 Dieselfant II "The Manatee"

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf Of Ben T Sent: Monday, May 27, 2002 1:17 AM To: vanagon@GERRY.VANAGON.COM Subject: Re: Removing & replace OEM cup holders

<<...All three are broken (bottom on each missing) and I wanted to know, are they easy to take out and even replace?...>>>

Dave, take a suitable sized drill bit and simply drill to through the center of the pop-rivet. They should come right off.

Replacement cuphlders of similar and some withimproved design are available your VW dealer, some listvendors such as Eurocampers, and most Marine and RV supply stores. AT one time even K-mart carried the les expensive variety which used all plastic construction instead of the ones with a metal flat tension spring in the OEM models.

Prices range from $2.99 to $15.00 each. I consider any prices higher than that a rip-off.

You can reinstall them with poprivets or in some cases with screws and nuts.

BenT

I see they are pop riveted in to my brown plastic interior siding. It's tempting to drill out each rivet to take them down.

However, I don't know if I can replace them with any cup holder, if I chose to do that. I'd rather not have 3 hole in my interior if I don't need too.

Anyhow, I wanted to know, has anyone successfully taken out the OEM cup holders (how?) and have you replaced them with different cup holders, in the original place (how?) and with what model cup holder?


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.