Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2002, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 23 May 2002 17:52:31 +0000
Reply-To:     Mike Finkbiner <mike_l_f@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike Finkbiner <mike_l_f@HOTMAIL.COM>
Subject:      Re: Someone must know what tire pressure do use in Agilis 51 tire
              s!
Content-Type: text/plain; format=flowed

"Terry K." <CTONLINE@WEBTV.NET> said -

Sean,

I kinda disagree with the response you gave---

If your running the van heavy, and the max load rating is at at specific pressure you best be running with what the tire mfg. recommends---not the vehicles mother----

Different tires, different pressures, different load ratings---

<SNIP>

Terry -

Tires, tire pressure, and all of the other suspension components work together. The vehicle manufacturer recommendations are what they think will give you good results with that size tire. That's why every vehicle has a recommended pressure plate permanently attached.

On my '87 Westy, the recommended rear pressure is 48 with a Commercial 185R and 40 with a LR 97 205R. The bigger 205s would be stiffer at the tire's maximum pressure, generally 50-60 for a LR 97, so they recommend a lower pressure.

You are right that the manufacturer knows what the max for the tire is, but unless you are carrying that much, you don't have to run it that high.

You will loose carrying capacity as you drop pressure, (which, I think, is why they recommend LR 97 for the 205 at 40 psi, but any Commercial, i.e. LR C for the 185 at 48 psi).

Sure, tires will differ, so I would say start with the vehicle manufacturers rating for that size, and go up or down a couple of pounds until it feels right on the road. Just don't go over the sidewall max, and keep in mind that lower pressure means lower carrying capacity. If you are loaded to the hilt, don't hesitate to bump up to a higher pressure. Commercial truck drivers regularly adjust pressure depending on load.

FWIW, I run my 195R14 Kumho 852s at 48 rear, 39 front. If it goes lower, the van feels too loose.

- Mike Finkbiner '87 Westy Moscow, ID mike_l_f@hotmail.com

_________________________________________________________________ Send and receive Hotmail on your mobile device: http://mobile.msn.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.