Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2002, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 23 May 2002 15:55:58 -0400
Reply-To:     Ben huot <huotx@VIDEOTRON.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Ben huot <huotx@VIDEOTRON.CA>
Subject:      Re: Yum, yum...(what a motor says when eating a rod)
Comments: To: Laurence Smith <lsmith@COGECO.CA>

Laurence,

I did not buy the gauge and sender; I am not pleased with the gauge accuracy. 80PSI is too much; I would prefer a 50PSI gauge. The westy engine idle between 5 and 10PSI, difficult to read on an 80PSI gauge. Even at 3000 RPM the pressure should be around 29 -35 PSI, again on a 80PSI gauge the margin of error is big.

Still looking for a 50PSI gauge.

Ben


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.